Old house wiring replacement in Blackwood
The first step is finding what is actually live. Houses are often partly rewired, and old runs get spliced into new ones. We trace each circuit, disconnect the knob and tube, and run new grounded cable to every device it served. Dead wiring left inside walls is disconnected at both ends.
People in Blackwood ask for this in different ways: knob and tube removal, knob and tube rewiring and knob and tube wiring replacement, or simply “old house wiring replacement near me”. It is all work we do, and one call to (888) 633-7804 covers it.
What is included
- Tracing of all live knob and tube circuits
- New grounded circuits to replace each run
- Removal of accessible old wiring in basements and attics
- Correction of old-to-new splices
- A letter describing the work for your insurer
- Permit and inspection
When to call for knob and tube wiring replacement in Blackwood
- You see ceramic knobs or tubes in the basement or attic
- An insurer or home inspector has flagged it
- You want to insulate the attic or walls
- Outlets are ungrounded and few
Not sure if this is what you need? Call (888) 633-7804, tell us what is happening in your Blackwood home or business, and we will point you to the right service.
What happens when you call
- We visit the property in Blackwood, look at the existing equipment and run a load calculation.
- You get a written, itemized price.
- We file for the permit and schedule the utility where the job needs it.
- We do the work in planned stages so you are without power as little as possible.
- The job is inspected, and we walk you through the finished work.
Knob and tube wiring replacement cost in Blackwood
The cost to replace knob and tube in Blackwood depends on how much is still live and how easy it is to reach. A house with a few remaining circuits is a very different job from one that was never updated.
Knob and tube removal near Grenloch and Clementon
Whether you are in the center of town or out toward Grenloch, it is the same crew and the same number: (888) 633-7804. We serve ZIP code 08012 and the neighboring towns of Grenloch, Clementon, Stratford and Somerdale.
In Camden County you can go from older homes near a downtown to farm properties and new developments within a few miles. Around Blackwood we wire barns, pole buildings and irrigation pumps as well as kitchens and panels, so bring us the odd jobs too.
Searching for “knob and tube rewiring near me” from Blackwood? You have found a local crew. Call (888) 633-7804.
Knob and Tube Wiring Replacement in nearby towns
- Knob and Tube Wiring Replacement in Grenloch
- Knob and Tube Wiring Replacement in Clementon
- Knob and Tube Wiring Replacement in Stratford
- Knob and Tube Wiring Replacement in Somerdale
- Knob and Tube Wiring Replacement in Glendora
- Knob and Tube Wiring Replacement in Sewell
- Knob and Tube Wiring Replacement in Magnolia
- Knob and Tube Wiring Replacement in Sicklerville
Knob and tube wiring replacement in Blackwood: common questions
Is knob and tube wiring illegal?
No, existing installations are allowed to remain. But it cannot be extended, it should not be covered with insulation, and many insurers will not accept it.
Can I insulate over knob and tube?
No. The wiring relies on open air to stay cool. Replace it first, then insulate.
Do you have to open the walls?
Less than you might think. Most new cable is fished from the basement and attic.
Do I need a permit for electrical work in Blackwood?
New circuits, panel changes and service work generally need a permit from the local construction office. Simple like-for-like replacements usually do not. We tell you when your job needs one.
Which towns near Blackwood do you serve?
We also work in Grenloch, Clementon and Stratford and the rest of Camden County.