Knob and tube rewiring in Butler
The first step is finding what is actually live. Houses are often partly rewired, and old runs get spliced into new ones. We trace each circuit, disconnect the knob and tube, and run new grounded cable to every device it served. Dead wiring left inside walls is disconnected at both ends.
We also get calls from Butler for old house wiring replacement, knob and tube wiring replacement and knob and tube removal. If you are not sure which one you need, describe the problem and we will tell you.
What is included
- Tracing of all live knob and tube circuits
- New grounded circuits to replace each run
- Removal of accessible old wiring in basements and attics
- Correction of old-to-new splices
- A letter describing the work for your insurer
- Permit and inspection
Signs you need knob and tube wiring replacement
- You see ceramic knobs or tubes in the basement or attic
- An insurer or home inspector has flagged it
- You want to insulate the attic or walls
- Outlets are ungrounded and few
Not sure if this is what you need? Call (888) 633-7804, tell us what is happening in your Butler home or business, and we will point you to the right service.
How the job goes, step by step
- We visit the property in Butler, look at the existing equipment and run a load calculation.
- You get a written, itemized price.
- We file for the permit and schedule the utility where the job needs it.
- We do the work in planned stages so you are without power as little as possible.
- The job is inspected, and we walk you through the finished work.
Knob and tube wiring replacement cost in Butler
The cost to replace knob and tube in Butler depends on how much is still live and how easy it is to reach. A house with a few remaining circuits is a very different job from one that was never updated.
Old house wiring replacement near Newfoundland and Bloomingdale
Whether you are in the center of town or out toward Newfoundland, it is the same crew and the same number: (888) 633-7804. We serve ZIP code 07405 and the neighboring towns of Newfoundland, Bloomingdale, Hibernia and Oak Ridge.
In the parts of Morris County that are on well water, a power problem also means no water, because the well pump is on the same panel. We keep that in mind on every call around Butler: pumps, septic alarms, sump pumps and heating controls get checked first, so the essentials are running before we move on to the rest.
If you searched for “knob and tube wiring replacement near Butler”, one more thing worth knowing: we coordinate with PSE&G, JCP&L, Atlantic City Electric, Rockland Electric or a municipal utility when a job needs the power company involved, so you do not have to.
Knob and Tube Wiring Replacement in nearby towns
- Knob and Tube Wiring Replacement in Newfoundland
- Knob and Tube Wiring Replacement in Bloomingdale
- Knob and Tube Wiring Replacement in Hibernia
- Knob and Tube Wiring Replacement in Oak Ridge
- Knob and Tube Wiring Replacement in Boonton
- Knob and Tube Wiring Replacement in Riverdale
- Knob and Tube Wiring Replacement in Towaco
- Knob and Tube Wiring Replacement in Rockaway
Knob and tube wiring replacement in Butler: common questions
Is knob and tube wiring illegal?
No, existing installations are allowed to remain. But it cannot be extended, it should not be covered with insulation, and many insurers will not accept it.
Can I insulate over knob and tube?
No. The wiring relies on open air to stay cool. Replace it first, then insulate.
Do you have to open the walls?
Less than you might think. Most new cable is fished from the basement and attic.
How do I book an electrician in Butler?
Call (888) 633-7804. Tell us what is happening and we will set a time.
Which towns near Butler do you serve?
We also work in Newfoundland, Bloomingdale and Hibernia and the rest of Morris County.