Knob and tube removal in Elmer
The first step is finding what is actually live. Houses are often partly rewired, and old runs get spliced into new ones. We trace each circuit, disconnect the knob and tube, and run new grounded cable to every device it served. Dead wiring left inside walls is disconnected at both ends.
People in Elmer ask for this in different ways: knob and tube rewiring, old house wiring replacement and knob and tube wiring replacement, or simply “knob and tube removal near me”. It is all work we do, and one call to (888) 633-7804 covers it.
What is included
- Tracing of all live knob and tube circuits
- New grounded circuits to replace each run
- Removal of accessible old wiring in basements and attics
- Correction of old-to-new splices
- A letter describing the work for your insurer
- Permit and inspection
When to call for knob and tube wiring replacement in Elmer
- You see ceramic knobs or tubes in the basement or attic
- An insurer or home inspector has flagged it
- You want to insulate the attic or walls
- Outlets are ungrounded and few
Not sure if this is what you need? Call (888) 633-7804, tell us what is happening in your Elmer home or business, and we will point you to the right service.
How the job goes, step by step
- We visit the property in Elmer, look at the existing equipment and run a load calculation.
- You get a written, itemized price.
- We file for the permit and schedule the utility where the job needs it.
- We do the work in planned stages so you are without power as little as possible.
- The job is inspected, and we walk you through the finished work.
Knob and tube wiring replacement cost in Elmer
The cost to replace knob and tube in Elmer depends on how much is still live and how easy it is to reach. A house with a few remaining circuits is a very different job from one that was never updated.
Knob and tube rewiring near Deerfield Street and Monroeville
Elmer is in Salem County, and our crews are in the area most days. If you are just outside town, we also work in Deerfield Street, Monroeville, Malaga and Norma. Here we cover ZIP code 08318.
Salem County has a lot of mid-century housing: ranches and split-levels from the 1950s through the 1970s. Some of those homes were wired with aluminum branch circuits, and many still have the original 100 amp panel. Both are fixable, and we do that work around Elmer regularly.
If you typed “old house wiring replacement near me” and landed here, you are in the right place. We work in Elmer and across South Jersey.
Knob and Tube Wiring Replacement in nearby towns
- Knob and Tube Wiring Replacement in Deerfield Street
- Knob and Tube Wiring Replacement in Monroeville
- Knob and Tube Wiring Replacement in Malaga
- Knob and Tube Wiring Replacement in Norma
- Knob and Tube Wiring Replacement in Rosenhayn
- Knob and Tube Wiring Replacement in Clayton
- Knob and Tube Wiring Replacement in Franklinville
- Knob and Tube Wiring Replacement in Newfield
Knob and tube wiring replacement in Elmer: common questions
Is knob and tube wiring illegal?
No, existing installations are allowed to remain. But it cannot be extended, it should not be covered with insulation, and many insurers will not accept it.
Can I insulate over knob and tube?
No. The wiring relies on open air to stay cool. Replace it first, then insulate.
Do you have to open the walls?
Less than you might think. Most new cable is fished from the basement and attic.
How do I book an electrician in Elmer?
Call (888) 633-7804. Tell us what is happening and we will set a time.
Which towns near Elmer do you serve?
We also work in Deerfield Street, Monroeville and Malaga and the rest of Salem County.