Knob and tube removal in Wanaque
The first step is finding what is actually live. Houses are often partly rewired, and old runs get spliced into new ones. We trace each circuit, disconnect the knob and tube, and run new grounded cable to every device it served. Dead wiring left inside walls is disconnected at both ends.
We also get calls from Wanaque for knob and tube wiring replacement, old house wiring replacement and knob and tube rewiring. If you are not sure which one you need, describe the problem and we will tell you.
What is included
- Tracing of all live knob and tube circuits
- New grounded circuits to replace each run
- Removal of accessible old wiring in basements and attics
- Correction of old-to-new splices
- A letter describing the work for your insurer
- Permit and inspection
Do you need knob and tube wiring replacement? Four signs
- You see ceramic knobs or tubes in the basement or attic
- An insurer or home inspector has flagged it
- You want to insulate the attic or walls
- Outlets are ungrounded and few
Not sure if this is what you need? Call (888) 633-7804, tell us what is happening in your Wanaque home or business, and we will point you to the right service.
How the job goes, step by step
- We visit the property in Wanaque, look at the existing equipment and run a load calculation.
- You get a written, itemized price.
- We file for the permit and schedule the utility where the job needs it.
- We do the work in planned stages so you are without power as little as possible.
- The job is inspected, and we walk you through the finished work.
Knob and tube wiring replacement cost in Wanaque
The cost to replace knob and tube in Wanaque depends on how much is still live and how easy it is to reach. A house with a few remaining circuits is a very different job from one that was never updated.
Knob and tube wiring replacement near Haskell and Ringwood
Wanaque is in Passaic County, and our crews are in the area most days. If you are just outside town, we also work in Haskell, Ringwood, Oakland and Pompton Lakes. Here we cover ZIP code 07465.
Much of Passaic County is wooded, and overhead lines run a long way through trees. When a storm comes through, power can stay out for a while. That is why so many of our calls around Wanaque are for standby generators, transfer switches, surge protection and well-pump circuits, along with the usual repairs.
If you searched for “old house wiring replacement near Wanaque”, one more thing worth knowing: we coordinate with PSE&G, JCP&L, Atlantic City Electric, Rockland Electric or a municipal utility when a job needs the power company involved, so you do not have to.
Knob and Tube Wiring Replacement in nearby towns
- Knob and Tube Wiring Replacement in Haskell
- Knob and Tube Wiring Replacement in Ringwood
- Knob and Tube Wiring Replacement in Oakland
- Knob and Tube Wiring Replacement in Pompton Lakes
- Knob and Tube Wiring Replacement in Bloomingdale
- Knob and Tube Wiring Replacement in Riverdale
- Knob and Tube Wiring Replacement in Franklin Lakes
- Knob and Tube Wiring Replacement in Mahwah
Knob and tube wiring replacement in Wanaque: common questions
Is knob and tube wiring illegal?
No, existing installations are allowed to remain. But it cannot be extended, it should not be covered with insulation, and many insurers will not accept it.
Can I insulate over knob and tube?
No. The wiring relies on open air to stay cool. Replace it first, then insulate.
Do you have to open the walls?
Less than you might think. Most new cable is fished from the basement and attic.
Do I need a permit for electrical work in Wanaque?
New circuits, panel changes and service work generally need a permit from the local construction office. Simple like-for-like replacements usually do not. We tell you when your job needs one.
Do you cover all of Wanaque?
Yes. We work throughout Wanaque and Passaic County, including ZIP code 07465.