Knob and tube rewiring in Windsor
The first step is finding what is actually live. Houses are often partly rewired, and old runs get spliced into new ones. We trace each circuit, disconnect the knob and tube, and run new grounded cable to every device it served. Dead wiring left inside walls is disconnected at both ends.
We also get calls from Windsor for knob and tube wiring replacement, knob and tube removal and old house wiring replacement. If you are not sure which one you need, describe the problem and we will tell you.
What is included
- Tracing of all live knob and tube circuits
- New grounded circuits to replace each run
- Removal of accessible old wiring in basements and attics
- Correction of old-to-new splices
- A letter describing the work for your insurer
- Permit and inspection
Do you need knob and tube wiring replacement? Four signs
- You see ceramic knobs or tubes in the basement or attic
- An insurer or home inspector has flagged it
- You want to insulate the attic or walls
- Outlets are ungrounded and few
Not sure if this is what you need? Call (888) 633-7804, tell us what is happening in your Windsor home or business, and we will point you to the right service.
From first call to finished job
- We visit the property in Windsor, look at the existing equipment and run a load calculation.
- You get a written, itemized price.
- We file for the permit and schedule the utility where the job needs it.
- We do the work in planned stages so you are without power as little as possible.
- The job is inspected, and we walk you through the finished work.
Knob and tube wiring replacement cost in Windsor
The cost to replace knob and tube in Windsor depends on how much is still live and how easy it is to reach. A house with a few remaining circuits is a very different job from one that was never updated.
Knob and tube wiring replacement near Hightstown and West Windsor
Whether you are in the center of town or out toward Hightstown, it is the same crew and the same number: (888) 633-7804. We serve ZIP code 08561 and the neighboring towns of Hightstown, West Windsor, Roosevelt and Cranbury.
A lot of people around Windsor commute, and more of them plug in a car every night. Across Mercer County we are adding Level 2 chargers, heat-pump circuits and 200 amp services to houses that were wired for a very different load thirty years ago.
If you searched for “knob and tube removal near Windsor”, one more thing worth knowing: we coordinate with PSE&G, JCP&L, Atlantic City Electric, Rockland Electric or a municipal utility when a job needs the power company involved, so you do not have to.
Knob and Tube Wiring Replacement in nearby towns
- Knob and Tube Wiring Replacement in Hightstown
- Knob and Tube Wiring Replacement in West Windsor
- Knob and Tube Wiring Replacement in Roosevelt
- Knob and Tube Wiring Replacement in Cranbury
- Knob and Tube Wiring Replacement in Allentown
- Knob and Tube Wiring Replacement in Plainsboro
- Knob and Tube Wiring Replacement in Imlaystown
- Knob and Tube Wiring Replacement in Millstone Township
Knob and tube wiring replacement in Windsor: common questions
Is knob and tube wiring illegal?
No, existing installations are allowed to remain. But it cannot be extended, it should not be covered with insulation, and many insurers will not accept it.
Can I insulate over knob and tube?
No. The wiring relies on open air to stay cool. Replace it first, then insulate.
Do you have to open the walls?
Less than you might think. Most new cable is fished from the basement and attic.
Which towns near Windsor do you serve?
We also work in Hightstown, West Windsor and Roosevelt and the rest of Mercer County.
Do I need a permit for electrical work in Windsor?
New circuits, panel changes and service work generally need a permit from the local construction office. Simple like-for-like replacements usually do not. We tell you when your job needs one.