Sub Panel Installation in Medford, NJ

Subpanel installation in Medford

We size the sub panel and its feeder from the loads it will serve, confirm the main panel can supply it, and run the feeder by the cleanest route. Neutrals and grounds are kept separate at the sub panel, and detached buildings get their own grounding electrodes.

You may have searched for “basement sub panel Medford”, “garage sub panel Medford” or “subpanel installation near me”. Whatever you call it, it is the same job and we do it every week in Burlington County.

What is included

Load check on the main panel
Feeder cable or conduit sized for the sub panel
60, 100 or 125 amp sub panel
Correct separation of neutrals and grounds
Ground rods for detached buildings
Labeled circuits and inspection

Signs you need sub panel installation

The main panel has no open slots
You are finishing a basement or building an addition
A detached garage or shed needs real power
Tandem breakers have been used to squeeze circuits in

Not sure if this is what you need? Call (888) 633-7804, tell us what is happening in your Medford home or business, and we will point you to the right service.

What happens when you call

We visit the property in Medford, look at the existing equipment and run a load calculation.
You get a written, itemized price.
We file for the permit and schedule the utility where the job needs it.
We do the work in planned stages so you are without power as little as possible.
The job is inspected, and we walk you through the finished work.

Sub panel installation cost in Medford

Sub panel installation cost in Medford comes down to the feeder length, the panel size and whether trenching or conduit is involved.

Basement sub panel near Marlton and West Berlin

Whether you are in the center of town or out toward Marlton, it is the same crew and the same number: (888) 633-7804. We serve ZIP code 08055 and the neighboring towns of Marlton, West Berlin, Lumberton and Mount Laurel.

Burlington County has a lot of mid-century housing: ranches and split-levels from the 1950s through the 1970s. Some of those homes were wired with aluminum branch circuits, and many still have the original 100 amp panel. Both are fixable, and we do that work around Medford regularly.

Searching for “sub panel installation near me” from Medford? You have found a local crew. Call (888) 633-7804.

Sub Panel Installation in nearby towns

Sub panel installation in Medford: common questions

Does a sub panel add capacity to my house?

No. It adds breaker spaces, not amps. If the service itself is too small, the fix is a service upgrade.

Can a sub panel go in a detached garage?

Yes. It needs a properly sized feeder, a disconnect and its own grounding.

How far can it be from the main panel?

As far as needed. For long runs we size the wire up to limit voltage drop.

Do I need a permit for electrical work in Medford?

New circuits, panel changes and service work generally need a permit from the local construction office. Simple like-for-like replacements usually do not. We tell you when your job needs one.

Are you open nights and weekends in Medford?

Our phone is answered 24 hours a day, every day. Call (888) 633-7804.

What customers say

Our old 100 amp panel was full and warm. They upgraded us to 200 amps in one day, labeled every breaker and dealt with the utility and the inspection. Power was back before dinner.
James K., Toms River

I needed a charger installed before my car arrived. They checked the panel, ran the circuit through the garage and set up the app with me. Neat conduit work and no surprises on the bill.
Priya S., Edison

They rewired our restaurant kitchen overnight so we did not lose a single service. Every circuit is labeled now and the breakers have stopped tripping on Friday nights.
Carlos V., Paterson

All electrical services in Medford, NJ

Panel directoryMedford, NJ 08055