Call (888) 633-7804

Sub Panel Installation in Washington, NJ

A finished basement, a workshop or an in-law suite in Washington runs better from its own panel. One feeder in, all the circuits you need at the other end.

Call (888) 633-7804All services in Washington

Subpanel installation in Washington

We size the sub panel and its feeder from the loads it will serve, confirm the main panel can supply it, and run the feeder by the cleanest route. Neutrals and grounds are kept separate at the sub panel, and detached buildings get their own grounding electrodes.

We also get calls from Washington for basement sub panel, garage sub panel and sub panel installation. If you are not sure which one you need, describe the problem and we will tell you.

What is included

  • Load check on the main panel
  • Feeder cable or conduit sized for the sub panel
  • 60, 100 or 125 amp sub panel
  • Correct separation of neutrals and grounds
  • Ground rods for detached buildings
  • Labeled circuits and inspection

Do you need sub panel installation? Four signs

  • The main panel has no open slots
  • You are finishing a basement or building an addition
  • A detached garage or shed needs real power
  • Tandem breakers have been used to squeeze circuits in

Not sure if this is what you need? Call (888) 633-7804, tell us what is happening in your Washington home or business, and we will point you to the right service.

From first call to finished job

  1. We visit the property in Washington, look at the existing equipment and run a load calculation.
  2. You get a written, itemized price.
  3. We file for the permit and schedule the utility where the job needs it.
  4. We do the work in planned stages so you are without power as little as possible.
  5. The job is inspected, and we walk you through the finished work.

Sub panel installation cost in Washington

Sub panel installation cost in Washington comes down to the feeder length, the panel size and whether trenching or conduit is involved.

Basement sub panel near Changewater and Broadway

Washington is in Warren County, and our crews are in the area most days. If you are just outside town, we also work in Changewater, Broadway, Oxford and Port Murray. Here we cover ZIP code 07882.

Warren County has everything from 1800s farmhouses to lake cottages that became year-round homes. Around Washington we often find a service that was sized for a much smaller house still feeding electric heat, a hot tub and a finished basement. Upgrading the service and adding proper circuits is routine work for us out here.

Searching for “garage sub panel near me” from Washington? You have found a local crew. Call (888) 633-7804.

Sub Panel Installation in nearby towns

Sub panel installation in Washington: common questions

Does a sub panel add capacity to my house?

No. It adds breaker spaces, not amps. If the service itself is too small, the fix is a service upgrade.

Can a sub panel go in a detached garage?

Yes. It needs a properly sized feeder, a disconnect and its own grounding.

How far can it be from the main panel?

As far as needed. For long runs we size the wire up to limit voltage drop.

How do I book an electrician in Washington?

Call (888) 633-7804. Tell us what is happening and we will set a time.

Do you cover all of Washington?

Yes. We work throughout Washington and Warren County, including ZIP code 07882.

What customers say

Our old 100 amp panel was full and warm. They upgraded us to 200 amps in one day, labeled every breaker and dealt with the utility and the inspection. Power was back before dinner.

James K., Toms River

They put a sub panel in my detached garage with 240 volts for the compressor and welder. Trenched, wired and inspected inside a week.

Steve H., Vineland

Eight recessed lights in a finished ceiling and not one patch needed. They laid out the spacing with me first, and the dimmer does not flicker. The kitchen looks twice the size.

Linda W., Freehold

Sub panel installation in Washington? Call us any time.

Call (888) 633-7804
Call now: (888) 633-7804