Call (888) 633-7804

Sub Panel Installation in Hillside, NJ

When the main panel is full or far from where the power is needed, a sub panel is the practical answer. We install them in Hillside garages, basements, additions and outbuildings.

Call (888) 633-7804All services in Hillside

Subpanel installation in Hillside

We size the sub panel and its feeder from the loads it will serve, confirm the main panel can supply it, and run the feeder by the cleanest route. Neutrals and grounds are kept separate at the sub panel, and detached buildings get their own grounding electrodes.

We also get calls from Hillside for garage sub panel, sub panel installation and basement sub panel. If you are not sure which one you need, describe the problem and we will tell you.

What is included

  • Load check on the main panel
  • Feeder cable or conduit sized for the sub panel
  • 60, 100 or 125 amp sub panel
  • Correct separation of neutrals and grounds
  • Ground rods for detached buildings
  • Labeled circuits and inspection

Signs you need sub panel installation

  • The main panel has no open slots
  • You are finishing a basement or building an addition
  • A detached garage or shed needs real power
  • Tandem breakers have been used to squeeze circuits in

Not sure if this is what you need? Call (888) 633-7804, tell us what is happening in your Hillside home or business, and we will point you to the right service.

How the job goes, step by step

  1. We visit the property in Hillside, look at the existing equipment and run a load calculation.
  2. You get a written, itemized price.
  3. We file for the permit and schedule the utility where the job needs it.
  4. We do the work in planned stages so you are without power as little as possible.
  5. The job is inspected, and we walk you through the finished work.

Sub panel installation cost in Hillside

Sub panel installation cost in Hillside comes down to the feeder length, the panel size and whether trenching or conduit is involved.

Garage sub panel near Irvington and Union

Our electricians cover every part of Hillside, Union County, including ZIP code 07205. We also take calls for sub panel installation in nearby Irvington, Union, Elizabeth and Maplewood.

Much of Union County was built before 1960: colonials, capes, two-family houses and brick apartment buildings with plaster walls. For an electrician that usually means 60 or 100 amp service, a mix of old cloth-covered cable and newer wire, and panels that were never meant to carry central air, an induction range and a car charger at the same time. We see it every week around Hillside and we plan the work around it.

If you searched for “sub panel installation near Hillside”, one more thing worth knowing: we coordinate with PSE&G, JCP&L, Atlantic City Electric, Rockland Electric or a municipal utility when a job needs the power company involved, so you do not have to.

Sub Panel Installation in nearby towns

Sub panel installation in Hillside: common questions

Does a sub panel add capacity to my house?

No. It adds breaker spaces, not amps. If the service itself is too small, the fix is a service upgrade.

Can a sub panel go in a detached garage?

Yes. It needs a properly sized feeder, a disconnect and its own grounding.

How far can it be from the main panel?

As far as needed. For long runs we size the wire up to limit voltage drop.

Do I need a permit for electrical work in Hillside?

New circuits, panel changes and service work generally need a permit from the local construction office. Simple like-for-like replacements usually do not. We tell you when your job needs one.

How do I book an electrician in Hillside?

Call (888) 633-7804. Tell us what is happening and we will set a time.

What customers say

Our old 100 amp panel was full and warm. They upgraded us to 200 amps in one day, labeled every breaker and dealt with the utility and the inspection. Power was back before dinner.

James K., Toms River

After the last storm we were done with extension cords. They sized the generator, handled the gas hookup and ran a full test. It has started by itself in every outage since.

Dave P., Morristown

Our house had aluminum wiring and the outlets were getting warm. They went through every box in the house and explained both options and the price for each. Very straight with us.

Tom R., Cherry Hill

Sub panel installation in Hillside? Call us any time.

Call (888) 633-7804
Call now: (888) 633-7804